Detaching The Rivets On A Gutter Spout

Drill out the rivets connecting the bottom elbow to the downspout with an appropriate size steel cutting drill bit.

Detaching the rivets on a gutter spout.

You ll be left with the original 1 8 hole the rivets went into. Start by drilling a 1 8 in. The drill bit will cut the rivet head away from the rivet body in a few seconds and the rivet is free. In this diy how to video tool dude tony shows you how to remove and replace downspouts on your home with a few basic hand tools.

Press the head of the rivet into the drill hole and squeeze the handle of your rivet gun to lock the rivet into place. Place the tip of the drill bit over the center indention on the rivet head and drill all the way through the rivet. Clamping these rivets down during the drilling process ensures that your gutter will not move and your drilling will be precise. This may require removing screws or rivets depending on how your gutters are attached but in either case it should be easy to free the section you need to work on.

Join the gutter to the corner with six rivets in the locations shown. Repeat for the opposite side until all rivets have been removed. Begin by detaching the compromised section of gutter so you can have full access to the leaky seam. After the holes are drilled for your rivets it s time to remove those clamps and start placing your rivets into place.

Now drill the remaining holes and install the rivets. If the gutter is badly rusted or has been heavily coated with tar that you can t scrape out spray on a special adhesive primer before applying the tape protecto tek is one brand but you may need to special order it. Us the hole in the rivet in the same manner as you would a centerpunch to guide the drill bit and drill the rivet out. Drill through the side of the downspout and into the connector.

Cut the tape with a scissors or a razor knife photo 2. Slide a rivet shaft into the rivet gun. Rivets at the front of the gutter and installing the first rivet with the rivet gun. Follow me http twitter.

Begin by selecting a hss high speed steel drill bit with a diameter slightly larger than the hole in the rivet head. Using a drill bit the same size as the old rivets in this case 1 8 drill straight through the center of the old rivet until it pops out of place. There is usually rivets on each side and on the front of the downspout. Repeat the drill and rivet on the other side of the downspout to connect it to the main gutter.