Difference Between Wood Screws And Sheet Metal Screws 6

Wood screws are tapered and thread count is not part of the description.

Difference between wood screws and sheet metal screws 6.

They are easier to drive into metal and will offer a greater level of strength and security. The threading on metal ones is available up to 3 inches and the wooden ones feature threading up to 1 inch. A gage number like 6 is the diameter and the length is the length of the screw that goes into the wood not inclusive of the head unless it s a flat head. These screws are not really interchangeable.

Wood screws over an inch long have a threadless shank that s about one quarter to one third the total length of the screw. If you re attempting to attach sheet metal you should choose metal screws. Be sure to drill an adequate body hole in the first board to prevent a jaced joint. Let us show you these differences so you can have all the information you need and use the right screw for the job.

These have a coarser pitch few threads per inch than sheet metal or machine screws and often have an unthreaded shank. Typically the threads extend from tip to head. Machine screws have finer threads than wood screws. Some wood screws are tapered from tip to head also.

The threads on wood screws usually are coarse and deep to help them grab the wood. Sheet metal screws have deeper closer sharper threads that always extend over the entire length of the screw. The sheet metal screws flaunt a straight shank along with a finer threading pattern other than the wooden rivets which are threaded only two thirds of the way up. In short wood screws are designed to be driven into wood materials while metal screws are designed to be driven into metal materials hence the names.

Although this is some times called a wood tapping screw it is basically a sheet metal design. There are distinct differences between drywall wood and deck screws that could be a huge factor on the ease of work as well as the integrity of the job done. The visible difference is in the thread. Wood screws have relatively wide spaced medium depth threads.

Sheet metal screws on the other hand always have a tighter sharper thread that cover their entire length. These screws usually are short and have coarse threads that are designed to grab onto relatively thin sheet metal. The smaller the gage number the smaller the screw diameter opposite of nails and wire diameter. Sheet metal screws are generally manufactured to a higher standard than ordinary wood screws.

The threadless shank allows the top piece of wood to be pulled flush against the under piece without getting caught on the threads.